Bulli for Concrete Surfaces

Bulli protects your cables in tunnels, on walls and on concrete ceilings and floors.

Thieves normally short-circuit the cable they want to steal, cut it on both ends and pull out the whole length.

The Bulli system anchors the cable so that it is impossible to easily remove the whole length of cable as before. The system inhibits horizontal movement to prevent pulling the cable out sideways to prevent upward pulling of the cable.

Not being able to pull out the cable, the thieves are now reduced to cutting the cable at every anchor. The time taken to steal the cable now exponentially increases the thieves  chances of getting caught.

Bulli installation steps for Surfaces

Position the clamps and drill the holes

Position bushes, saddle and cable

Insert the anchors and fix the nuts

Tighten the nuts and snap them off

Drill 4 x 10mm holes, 85mm deep at the installation position using the cable saddle holes as a guide.

Position the bushes around the cable and place the cable saddle over the bushes.

Insert the 4 anchors through the saddle holes into the concrete holes drilled previously..

Tighten all 4 shear nuts until they snap off.

Your cable is now secure.